TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1072 of 1205
8-10. REAR WHEEL TOE-OUT ALIGNMENT (Cont’d) c. Toe-out Adjustment TM 9-2320-387-24-1 8-34 Change 1 1. Loosen two locknuts (1) and screws (1.1) securing clamps (3) on each adjusting sleeve (2). NOTE Toe-in can be increased or decreased by changing length of tie rods. A threaded sleeve is provided for this purpose. Both tie rods must be the same length ± 1/8 in. (3 mm) after adjustment. 2. Turn each adjusting sleeve (2) equally, but in opposite directions. 3. Roll vehicle rearward, then forward, to original position. 4. Repeat toe-in check and adjustment procedures until correct adjustment is indicated. CAUTION Ensure bolt and nut on adjusting sleeve clamp nearest to geared hub is facing halfshaft. Bolt and nut on adjusting sleeve clamp nearest to frame must be facing 180° away from stabilizer bar to prevent damage to equipment. 5. Secure two clamps (3) on each adjusting sleeve (2) with two screws (1.1) and locknuts (1). Tighten locknuts (1) to 30 lb-ft (40 N • m). FOLLOW-ON TASK: Operate vehicle (TM 9-2320-387-10) and check for pull or wander. 1 3 2 1.1