TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1055 of 1205
TM 9-2320-387-24-l 8-5. RUNFLAT COMPRESSOR (P/N J39250) BELT REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools %&al mechanic’s tool kit: automotive (Appendix B, Item 1) Materials/P&s Runflat belt repair kit (Appendix G, Item 364) Manual References TM 9-2320-387-24P Maintenance Level Unit p?iizi-l NOTE Note position of belt for installation. 1. Remove small pin (8) from belt (4) and worm gear shaft assembly (1). Discard small pin (8). 2. Remove shaft pin (7) and worm gear shaft assembly (1) from compressor assembly (6). Discard shaft pin (7). 3. Remove two locknuts (51, socket-head screws (21, spacers (31, and belt (4) from compressor assembly (6). Discard locknuts (51. I- b. Installation 1 NOTE Belt overlap is to be positioned so there is an equal amount of belt on each side of worm gear shaft assembly. 1. Install belt (4) on compressor assembly (6) with two spacers (3), socket-head screws (2), and locknuts 6). 2. Install worm gear shaft assembly (1) on compressor assembly (6) with shaft pin (7). 3. Install belt (4) to worm gear shaft assembly (1) with small pin (8). 8-17