TM-9-2320-387-24 HMMWV Direct Support & General Support Maintenance Manual Volume 1 Download
Page 1015 of 1205
TM9-2320-387-24-l 7-l 1. BRAKE PROTECTION GUARDS REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Appendix B, Item 1) MaterialsZarts Six locknuts (Appendix G, Item 156) Manual References TM 9-2320-387-24P EquipmentCondition Vehicle raised and supported (para. 8-2). Maintenance Level Unit NOTE The replacement procedure for brake protection guards is basically the same for front and rear brakes. This procedure covers the front brake protection guards. a. Removal 1. Remove four locknuts (41,washers (5), capscrews (71,washers (51,and two right-side brake protection guards (8) from brackets (6) on crossmembers (9). Discard locknuts (4). 2. Remove two locknuts (31, washers (21, capscrews (101, washers (21, and left-side brake protection guard (11) from brackets (1) on crossmembers (9). Discard locknuts (3). (J 1. Install left-side brake protection guard (11) on two brackets (1) on crossmembers (9) with two washers (2), capscrews (101, washers (21, and locknuts (3). 2. Install two right-side brake protection guards (8) on two brackets (6) on crossmembers (9) with four washers (5), capscrews (7), washers (5), and locknuts (4). 7-34