TM-9-2320-387-10 HMMWV Operator Manual Download
Page 253 of 277
TM 9-2320-387-10 G-4 Change 1 USAGE FLUID/LUBRICANT CAPACITIES Steering Dexron ® II or 1 qt (0.95 L) All Temperatures System Dexron ® III w/Cooler 1.25 qt (1.18 L) Upper and GAA As Required All Temperatures Lower Ball (MIL-G-10924) Joints, Tie Rod Ends, Pitman Arm, Propeller Shafts, etc. Hinges, Cables, OE/HDO As Required All Temperatures and Linkages OE/HDO 15/40 (Grade 15W-40) lubricant may be used when expected temperatures are above +5°F (-15°C). If OEA lubricant is required to meet the temperature ranges prescribed in the lubrication table, then the OEA lubricant is to be used in place of OE/HDO 10 lubricant for all temperature ranges. If operating conditions are severe or abnormal, service chassis lubrication points at 1,000 mi (1,609 km). Door Latches PL-S As Required All Temperatures and Wire (VV-L-800) Handle Lock GREASE, WIRE ROPE (MIL-G-18458) ALL TEMPERATURES EXPECTED TEMPERATURES Table G-1. Lubrication (Cont’d). FUEL REQUIREMENTS — TEMPERATURE LIMITS (VV-F-800) Grade DF2 Fuel For use above +10°F (-12°C)* Grade DF1** For use below +10°F (-12°C) to above -20°F (-29°C) Grade DFA For use below -20°F (-29°C) Grade JP-8 All Temperatures * Temperature limits may vary, dependent on the cloud point of the actual DF2 fuel being supplied in the geographical area. ** DF1 is not normally procured in CONUS or OCONUS. Refineries will blend DF2 with kerosene to meet temperature requirements of DF1.