TM-9-2320-387-10 HMMWV Operator Manual Download
Page 176 of 277
TM 9-2320-387-10 2-128 d. Removal of Rear Curtain. (1) Detach curtain straps (5) from footman loops (7) behind seats by depressing locking tabs (6). NOTE Perform step 2 if vehicle is equipped with two-man arctic cab. (2) Peel curtain (4) back from fastener tape (8). (3) Unfasten eyelets (3) from turnbuttons (2) on B-pillar (1). (4) Remove rear curtain (4) from B-pillar (1). e. Installation of Rear Curtain. (1) Install rear curtain (4) on B-pillar (1) by fastening eyelets (3) to turn- buttons (2). NOTE Perform step 2 if vehicle is equipped with two-man arctic cab. (2) Attach curtain (4) to fastener tape (8). (3) Attach curtain straps (5) to footman loops (7) located behind seats. Tighten straps (5) equally, but do not overtighten. f. Installation of Cab Roof Cover, Rails, and Bow Assembly. (1) Install two horizontal rails (12) on A-pillar (13) and B-pillar (1), and secure with four screws (9). The short end of horizontal rails (12) goes toward front of vehicle. (2) Loosen end bracket screws (14) and install bow assembly (11) on horizontal rails (12). Secure with four screws (10) and tighten bracket screws (14). (3) Slide cab roof cover (18) into channel (15) on A-pillar (13) and roll cab roof cover (18) over cab. (4) Install cab roof cover (18) over rear curtain (4) at B-pillar (1) and fasten eyelets (3) to turnbuttons (2) on B-pillar (1) and A-pillar (13). (5) Position cab roof cover (18) around two horizontal rails (12) and fasten eyelets (16) to turnbuttons (19). Secure cab roof cover (18) to bow assembly (11) with hook and loop attachments (17). 2-54. REMOVAL AND INSTALLATION OF TWO-MAN CREW AREA SOFT TOP ENCLOSURE (Cont'd)