TM-9-2320-387-10 HMMWV Operator Manual Download
Page 130 of 277
TM 9-2320-387-10 2-82 a. Tool Removal. (1) Open cargo shell door (para. 2-32). (2) Lower tailgate (para. 2-22). (3) Disconnect four strap assemblies (2) securing ax (3) and max tool carrying bag (1) to tailgate (4). Remove ax (3) and max tool carrying bag (1). (4) Remove the following attachments from max tool carrying bag (1): • Reversible rake/hoe attachment (11) • Rake/hoe thumbscrew attachment (10) • Shovel attachment (5) • Six safety locking pins (7) • Broad pick attachment (9) • Pick attachment (8) • Mattock attachment (6) NOTE • Using the ax and attachments, the max tool kit can be incorporated into seven basic hand tools. • Ax blade must be covered with sheath before using kit. • Read all safety and assembly instructions enclosed with max tool kit before using kit. b. Reversible Rake/Hoe Attachment. (1) Connect rake/hoe attachment (11) (with either rake or hoe in the working position) into socket (12) on end of ax (3). NOTE Thumbscrew must be seated tightly in rake/hoe attachment and socket of ax. Check thumbscrew often to be sure it does not work loose. (2) Install thumbscrew (10) on rake/hoe attachment (11) and in socket (12) of ax (3). Tighten thumbscrew (10). (3) To remove rake/hoe attachment (11), remove thumbscrew (10) from rake/hoe attachment (11) and ax (3). c. Shovel Attachment. NOTE Shovel attachment is shown. Broad pick, pick, and mattock attachments are attached basically the same. (1) Connect shovel attachment (5) into socket (12) on end of ax (3). (2) Insert safety locking pin (7) into hole in end of taper on shovel attachment (5). (3) To remove shovel attachment (5), remove safety locking pin (7) from shovel attachment (5) and ax (3). d. Tool Installation. (1) Replace attachments in max tool carrying bag (1). (2) Install max tool carrying bag (1) and ax (3) on tailgate (4) with four strap assemblies (2). (3) Raise tailgate (para. 2-22). (4) Close cargo shell door (para. 2-32). 2-25. MAX TOOL KIT STOWAGE (M1114) OPERATION