TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 74 of 353
TM 9-2320-362-14&P 3-23. STORAGE BOX REPAIR This task covers: a. Hinge Removal c. Strike and Clamping Catch Removal b. Hinge Installation d. Strike and Clamping Catch Installation INITIAL SETUP: Tools General mechanic’s tool kit: automotive (Item 1, Section III, Appendix B) Electric drill, (Item 2, Section III, Appendix B) Drill bit, 3/16-inch, (Item 2, Section 111, Appendix B) Riveter, blind hand (Item 2, Section III, Appendix B) Materials/Parts Ten dome head rivets P/N 1601-0619 Materials/Parts (Cont’d) Two lockwashers P/N MS35338-136 Two self-locking nuts P/N MS21044CO6 Equipment Condition Storage box removed (para 3-22a) General Safety Instructions When drilling, be sure to wear goggles for eye protection. 1. File small flat on rivet heads (3). 2. Center punch flats while supporting rivet backsides. WARNING When drilling, be sure to wear goggles for eye protection or injury to personnel may occur. 3. Using 3/16-inch drill bit, drill through all rivet heads (3). 4. Pry off rivet heads hinge (2). (3) and tap out rivet shanks. Remove b. Hinge Installation 1. Place hinge (2) in position. 2. Rivet hinge to storage box (1) and storage box cover (4). 3-44