TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 31 of 353
3-4. 3-5. TM 9-2320-362-14&P CHAPTER 3 UNIT MAINTENANCE Section I. LUBRICATION INSTRUCTIONS . 3-1. LUBRICATION ACCORDING TO HIGH ENGINE IDLE TIME LOAD Due to the mission profile, this vehicle operates under unusual conditions (high idle time load). Therefore, mileage identified by LO 9-2320-280-12 for the vehicle is not sufficient; mileage plus engine idle time (using hourmeter) must be used. One hour of engine idle time is equal to 30 miles of travel. The vehicle log should be updated daily to reflect engine idle time and equivalent mileage (idle time in hours multiplied by 30 miles equals the equivalent mileage). Section II. REPAIR PARTS; SPECIAL TOOLS; TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE); AND SUPPORT EQUIPMENT 3-2. COMMON TOOLS AND EQUIPMENT For authorized common tools and equipment, refer to the Modified Table of Organization and Equipment (MTOE) applicable to your unit. 3-3. SPECIAL TOOLS, TMDE, AND SUPPORT EQUIPMENT Special tools, TMDE, and support equipment are listed and illustrated in appendix D of this manual. Repair parts are listed and illustrated in appendix D of this manual. Section III. SERVICE UPON RECEIPT a. Upon receipt of new, used, or reconditioned kit, you must determine if the equipment has been service. The following steps should be followed: (1) Inspect all assemblies, subassemblies, sure they are in proper working order. (2) Secure, clean, lubricate, or adjust as components of the EES properly prepared for and accessories to be needed. (3) Check all equipment to be sure every item is present, in good condition, and properly mounted or stowed. b. The operator will assist when performing service upon receipt inspections. 3-1