TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 202 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) ii. Ladder Mount Installation 1. 2. 3. 4. 5. 6. 7. Remove two plastic cap plugs (1) from wheelhouse (6). Using ladder retaining bracket (4) as a template, align two holes in ladder retaining bracket (4) with two holes in wheelhouse (6). Determine center of third hole (5) and remove ladder retaining bracket (4). WARNING ● When drilling, be sure to wear goggles for eye protection or injury to personnel may occur. ● Avoid skin contact with paint, primer, remover, and thinner particularly if there are cuts or open wounds on the hand. Failure to do so could result in serious injury. Using 9/32-inch drill bit, drill hole (5) in wheelhouse (6). Secure ladder retaining bracket (4) to wheelhouse (6) with screws (2), washers (3), and self-locking nuts (15). Install ladder strap assembly (10) to ladder strap bracket (13) and secure with screws (14) and nuts (12). Remove two screws (11), washers (8), and self-locking nuts (7) that secure tailgate bracket (9) to wheelhouse (6). Remove tailgate bracket (9) and retain screws (11), washers (8), and self-locking nuts (7), Place ladder strap bracket (13) over tailgate bracket (9). Secure with two screws (11), washers (8), and self-locking nuts (7). 4-90