TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 200 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) NOTE It may be necessary to lift floor insulation to find location of perforations. 6. 7. Cut out floor insulation (6) at perforations (7). Mark outline of perforation on floor. Roll back floor insulation (6). Place rifle mount (2) on floor (9) so that base of rifle mount (2) is centered in outline and rests flat against inclined section of floor (9). Using rifle mount (2) as template, determine center of three holes (1). Remove rifle mount (2). 8. WARNING When drilling, be sure to wear goggles for eye protection or injury to personnel may occur. Avoid skin contact with paint, primer, remover, and thinner particularly if there are cuts or open wounds on the hand. Failure to do so could result in serious injury. Using 3/8-inch drill bit, drill three holes (1) into floor (9). Using three capscrews (3), six washers (4), and three self-locking nuts (8), install rifle mount (2) onto floor (9) of vehicle. Roll floor insulation (6) back over rifle mount (2). 9. 10. 11. 4-88