TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 198 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) hh. M16 Rifle Mount Installation 1. 2. 3. 4. 5. NOTE Procedures for replacing the left and right rifle mounts are procedure covers Align holes on left side dashboard bracket (1). Using clamp bracket (4), dashboard bracket (l). When drilling, basically the same. This the right rifle mount. of clamp bracket (4) with rivets (2) on determine center of two new holes (3) on WARNING be sure to wear goggles for eye protection or injury to personnel may occur. Avoid skin contact with paint, primer, remover, and thinner particularly if there are cuts or open wounds on the hand. Failure to do so could result in serious injury. NOTE Pin may need to be removed from hinge on driver’s side for easier installation. Using 1/4-inch drill bit, drill out two new holes (3). NOTE Stuffing rag in hole at top of support may prevent loss of hardware or tools. Using two capscrews (6), washers (5), and self-locking nuts (11), install clamp bracket (4), NOTE Ensure spring-loaded side of mounting clamp is to outside of vehicle. Using two machine screws (7), washers (9), and self-locking nuts (10), install mounting clamp (8). 4-86