TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 194 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) ff. Hand Throttle Cable Installation 1. 2. 3. 4. 5. 6. 7. 8. 9. 4-82 Remove existing hand throttle cable and bracket (TM 9-2320-280-20). Retain the following items: (a) Hitch pin (17) and washer (18) that secures clevis (20) to accelerator rod (19); (b) Two capscrews (1) and four washers (2) from lower mounting bracket; and (c) Capscrew (13), two washers (7), screw (14), and nut (5) from upper mounting bracket. Attach hand throttle bracket (8) to instrument panel (9) with screw (14) and nut (5). Do not tighten. Secure hand throttle bracket (8) to instrument panel (9) with capscrew (13), two washers (7), and locknut (6). Tighten screw (14) and nut (5) that secures hand throttle bracket (8) to instrument panel (9). Install hand throttle cable (15) to hand throttle bracket (8). Secure by tightening nut (10) and lockwasher (11) on hand throttle cable (15). Install hand throttle cable (15) to throttle cable end bracket (16). Tighten two washers (4) and nuts (3) on hand throttle cable (15). Install throttle cable end bracket (16) on cowl and secure with two capscrews (1), four washers (2), and two self-locking nuts (12). Secure clevis (20) to accelerator rod (19) with washer (18) and hitch pin (17).