TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 186 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) 7. From engine side, route wire no. 28 (2) through cowl grommet (1) behind 200 amp alternator. 8. Slide rubber shell (3) and plastic sleeve (4) from connector onto wire no. 28 (2). 9. Strip insulation 1/4-inch (0.64 cm) from end of wire no. 28 (2). 10. Install connector terminal (5) onto wire no. 28 (2) and crimp. WARNING To prevent eye injury, wear protective eye wear while performing any soldering. 11. Solder crimped joint between connector terminal (5) and wire no. 28 (2). 12. Slide plastic sleeve (4) and rubber shell (3) onto connector terminal (5). 4-74