TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download

Page 158 of 353

TM 9-2320-362-14&P 4.18 EES KIT INSTALLATION (Cent’d) 17. Remove passenger side fixed rear door (1) (TM 9-2320-280-20). 18. Determine center of four holes (2), (3), (4), and (5) on fixed rear door (1) as follows: (a) Measure 2 inches (5.08 cm) down from top edge and 8 l/2-inches (21.59 cm) over from right edge for hole (2). (b) Measure 12 inches (30.48 cm) down from top edge and 8 l/2-inches (21.59 cm) over from right edge for hole (3). (c)Measure 19 inches (48.26 cm) over from right edge and 12 inches (30.48 cm) down from top edge for hole (4). (d) Measure 2 inches (5.08 cm) down from top edge and 19 inches (48.26 cm) over from right edge for hole (5). WARNING When drilling, be sure to wear goggles for eye protection or injury to personnel may occur. Avoid skin contact with paint, primer, remover, and thinner particularly if there are cuts or open wounds on the hand. Failure to do so could result in serious injury. NOTE Before drilling in fixed rear door, check loca- tion of holes with holes in cover of power in- terface box. 19. Using 5/16-inch drill bit, drill four holes (2), (3), (4), and (5) in fixed rear door (l). 4-46