TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 155 of 353
TM 9-2320-362-14&P 4-18. EES KIT INSTALLATION (Cont’d) 7. Determine center of hole (1) on right side of transmission tunnel (3) as follows: (a) Measure 3 7/8-inch (9.84 cm) from rear of battery box (4), and (b) Measure 1 5/8-inch (4.13 cm) from wall on transmission tunnel (3). WARNING When drilling, be sure to wear goggles for eye protection or injury to personnel may occur. Avoid skin contact with paint, primer, remover, and thinner particularly if there are cuts or open wounds on the hand. Failure to do so could result in serious injury. 8. Using 2 5/8-inch hole saw, drill hole (1) in right side of transmission tunnel (3). 9. Install protector (2) in hole (1). 4-43