TM-9-2320-362-14&P HMMWV Technical Manual Electrical Environmental System (EES) Download
Page 15 of 353
TM 9-2320-362-14&P ● Tools and Special Tools: Those tools, tool kits, and special tools needed to complete a task. If no tools, tool kits, or special tools are required, this heading will not be used. If you don’t have one of these special tools, requisition it (before starting the task) using the data supplied in the RPSTL, appendix D, for your level of maintenance. Special tools are located in section III. ● Materials/Parts: This heading lists only mandatory replacement materials or parts (gaskets, “O” rings, sealant, etc.). To replace other unserviceable parts, refer to appendix D for requisition data. If no mandatory replacement materials/parts are required, this heading will not be used. ● Personnel Required: The number of personnel needed to perform a task. If only one mechanic is needed, this heading will not be used. NOTE If you think that you need more help to adequately or safely complete a task, perhaps as the result of unusual conditions, etc., alert your supervisor and ask for help. ● Manual References: Those TMs needed to complete the task. If no other TMs are needed, this heading will not be used. ● Equipment Conditions: Notes the conditions that must exist before starting the task. If none are required, this heading will not be used. For the tachometer replacement, the engine should be shut off before we can start the task. If not already done, follow the procedure for engine shut off in TM 9-2320-280- 10, before proceeding with this task. ● General Safety Instructions: Summarizes all safety warnings for the maintenance task. If none are required, this heading will not be used. 3. A step by step maintenance procedure follows the “INITIAL SETUP” and gives detailed instructions for the procedure. These instructions give the part’s general location and name and action performed. In the example, tachometer replacement - a. Removal, step 1 is : “Remove seven screws (2), lockwashers (3), and washers (1) from tach/hourmeter box cover (4). Discard lockwashers (3).” Note that the numbers in parenthesis correspond to the part’s callout number in the accompanying illustration. xi