Covering the politics, Business and technology of defense - Subscribe Today

TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download

Page 958 of 1258

TM 9-2320-280-34 18 - 3. TRANSFER CASE REPAIR (Model 218) (Cont’d) 13. Install planetary assembly (1) until seated on input gear (4), and position range fork lug (2) into detent slot in range sector (3). 14. Install two seal washers (7) on oil cooler manifolds (6) and position oil cooler (5) in front case (10). CAUTION Do not over-torque retaining nuts, or internal damage to the transfer case oil cooler may result. 15. Install two washers (8) and nuts (9) securing oil cooler (5) to front case (10), ensuring narrow side of washers (8) is next to nuts (9). Hold the end of the oil cooler stationary and use a pound-inch torque wrench to tighten nuts (9) to 192-216 lb-in. (22-24 N • m). NOTE Oil in case bore may prevent shift rail from seating completely and prevent rear case installation. 16. Remove all traces of oil from shift rail bore in front case (10). NOTE Tapered end of shift rail must point up. 17. Install shift rail (11) through range fork (12) and into shift rail bore in front case (10). Be sure shift rail (11) is seated. 18-18