TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 929 of 1258
TM 9-2320-280-34 17-30. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (4L80-e) (Cont’d) 7. Determine correct apply pin to be used from table below: NOTE * Apply pins are identified by the number of rings around small end of apply pins. * If necessary to change apply pin, refer to rear servo repair para. 17- 27. Table 17-7. Apply Pin Selection a. If both flats are above gauge surface, use pin length #1. b. If one flat is above gauge surface, use pin length #2. c. If both flats are below gauge surface, rotate to side B. d. If both flats are above gauge surface, use pin length #3. e. If one flat is above gauge surface, use pin length #4. f. If both flats are below gauge surface, rotate to side C. g. If both flats are above gauge surface, use pin length #5. h. If one flat is above gauge surface, use pin length #6. i. If both flats are below gauge surface, use pin length #7. 8. Remove checking tool and gauge pin. 17-143