TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download

Page 856 of 1258

TM 9-2320-280-34 17-76 Change 1 17-14. TRANSMISSION DISASSEMBLY INTO SUBASSEMBLIES (4L80-E) (Cont’d) NOTE Wave plate is used on 1997 and 1998 transmissions only. Remove snapring (3), backing plate (2), four clutch plate assemblies (4), clutch plates (1), and wave plate (5.1) from transmission case (5). CAUTION Correct torque for installed center support bolt should be 29 lb-ft (39 N m). If not tightened to minimum torque, case could be damaged. If center support bolt is not tightened to minimum torque, a new center support and bolt should be installed during reassembly to avoid component damage. 1. Check center support bolt (6) for torque. 2. Remove and discard center support bolt (6). 3. Remove snapring (7) from transmission case (5). 4. Attach gear unit installer/remover tool and slide hammer to main shaft (8). 5. Lift gear unit (9) out of transmission case (5). 6. Remove thrust washer (10) from gear unit (9). 7. Remove spacer (11), rear band (12), and thrust washer (13) from transmission case (5). Remove center support (14) and thrust washer (15) from gear unit (9). q. Center Support Assembly p. Gear Unit Assembly and Rear Band o. Intermediate Clutch Assembly