TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 834 of 1258
TM 9-2320-280-34 17-13. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (3L80) (Cont’d) NOTE Install six check balls only; the seventh check ball is not required. k. Detent Soleniod 1. Install six check balls (2) in ballseat pockets in case (1). 2. Install two guide pins in case (1). NOTE Spacer plate gasket is marked "C". 3. Install spacer plate gasket (13) over guide pins. 4. Install spacer plate (12) over guide pins. 5. Install detent solenoid (4) on spacer plate (12) with two capscrews (5). Do not tighten capscrews (5) at this time. 6. Install O-ring seal (16) on electrical connector (15). Align tab (14) on electrical connector (15) with notch in side of case (1) and install electrical connector (15) into case (1). 7. Connect detent solenoid lead (3) to electrical connector (15). l. Front Servo 1. Install front servo spring (11) and spring retainer (10) into front servo piston bore in case (1). 2. Install retaining ring (8) in front servo pin (9) and install servo pin (9) in case (1) so that tapered end of servo pin (9) contacts front band. NOTE The teflon ring allows the front servo piston to slide very freely in case. The free fit of teflon ring is. normal and does not indicate leakage. The teflon ring should only be replaced if it shows damage or evidence of leakage. 3. Install seal ring (7) on piston (6) if removed. Install servo piston (6), with flat side of servo piston (6) facing up, on servo pin (9). 17-56