TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 832 of 1258
TM 9-230-280-34 17-13. TRANSMISSION ASSEMBLY FROM SUBASSEMBLIES (3LB80) (Cont’d) i Oil Pump 1. Install two guide pins in case (5). 2. Coat oil sealing rings on oil pump (1) with petrolatum. 3. Install oil pump gasket (4) over guide pins. 4. Install oil pump (1) over guide pins and into case (5). 5. Using wooden handle, lightly tap oil pump (1) into case (5) far enough to start capscrews (2). 6. Remove guide pins and install five seal washers (3) and capscrews (2). Leave one threaded capscrew hole in oil pump (1) open. CAUTION If turbine shaft cannot be rotated as pump is being pulled in place, forward or direct clutch housing has not been properly installed. This condition must be corrected before oil pump is pulled fully in place or transmission damage will result. 7. Evenly tighten capscrews (2) securing oil pump (1) to case (5) to 16-20 lb-ft (22-27 N • m). 17-54