TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 816 of 1258
TM 9-2320-280-34 17-10. GEAR UNIT REPAIR (3L80) (Cont’d) c. Inspection NOTE For general inspection instructions, refer to para. 2-14. ' 1. Inspect output carrier (2) for damage. Replace if damaged. 2. Inspect output carrier pinion gears (1) for damage, rough bearings, or excessive end play. Using feeler gauge, measure pinion gear end play; end play should not exceed 0.024 in. (0.61 mm). If any of these conditions exist, replace output carrier (2). 3. Inspect band surface (4) on reaction carrier (3) for burning, scoring, or galling. Replace if burnt, scored, or galled. 4. Inspect reaction carrier bushing (5). Replace reaction carrier (3) if bushing (5) is damaged. 5. Inspect reaction carrier pinion gear (6) for damage, rough bearings, or excessive end play. Using feeler gauge, measure pinion gear end play; end play should not exceed 0.024 in. (0.61 mm). If any of these conditions exist, replace reaction carrier (3). 6. Inspect roller clutch (10) for damaged rollers (8), springs (7), or cage (9). Replace roller clutch (10) if any parts are damaged. 7. Inspect snapring (11), case thrust washer (12), reaction carrier thrust washer (13), and front internal gear ring (14) for distortion or damage. Replace any part distorted or damaged. NOTE Rear band was removed during transmission disassembly (para. 17-3). 8. Inspect rear band (15) for burning, scoring, distortion, or other damage. Replace if burnt, scored, distorted, or otherwise damaged. 17-38