TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 753 of 1258
15-3. 6,000 LB. WINCH REPAIR (Cont’d) 7. Install clutch ring gear (2) into end housing (1) with pointed ends of gear teeth facing in. 8. Install O-ring seal (14) on clutch lever (13) and apply aircraft grease to unpainted surfaces of clutch lever (13). 9. Align groove in clutch ring gear (2) with hole in end housing (1) and install clutch lever (13) in end housing (1). CAUTION Do not tighten setscrew past flush with housing, or damage to winch may result. 10. Install ball (12), spring (11), and setscrew (10) in end housing (1). 11. Apply aircraft grease to stage one sun gear (3), stage one gear carrier (4), and stage two gear carrier (5) and install in end housing (1). 12. Apply aircraft grease to thrust bushing (6) and stage three gear carrier (7) and install in end housing (1). 13. Install gasket (8) and ring gear (9) on end housing (1). 14. Install end housing (1), ring gear (9), and gasket (8) on drum support (15), ensure to align reference marks and secure with ten socket-head screws (16). Using hex-head driver, tighten screws (16) to 35 lb-in. (4 N•m). TM 9-2320-280-34 15-12 Change 1 NEW CONFIGURATION