TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 752 of 1258
15-3. 6,000 LB. WINCH REPAIR (Cont’d) TM 9-2320-280-34 Change 1 15-11 NOTE For general inspection instructions, refer to para. 2-16. 1. Install three tie rods (21) into drum support (19) with three locknuts (18). 2. Install drive shaft (20) in brake assembly (12) and apply aircraft grease to brake assembly (12). 3. While holding driveshaft (20), rotate brake assembly (12) to compress for installation, and install in drum (17). 4. Apply aircraft grease to thrust bushing (16) and install thrust bushing (16) and drum (17) on drum support (19). NOTE Perform step 5 for vehicles with old configuration only. 5. Install retaining ring (23) on spline drive (24) and install both in drum (17). 6. Apply aircraft grease to thrust bushing (16). Install thrust bushing (16) and drum support (22) on drum (17) and tie rods (21) with three locknuts (15). Tighten locknuts (15) and (18) to 18 lb-ft (25 N•m). OLD CONFIGURATION d. Assembly