TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 749 of 1258
15-3. 6,000 LB. WINCH REPAIR (Cont’d) 10. Inspect end housing (1) for damage. Replace if damaged. NOTE Perform steps 11 and 12 for vehicles with old configuration only. 11. Inspect end housing bushing (2) for damage or wear. Replace with new configuration end housing (1) if damaged or worn. If bushing (2) is to be reused, lubricate with bushing grease. 12. Inspect gear teeth, splines, and machined surfaces of clutch ring gear (3), stage one sun gear (4), stage one gear carrier (5), stage two gear carrier (6), stage three gear carrier (9), ring gear (8), and splined drive (7) for damage. Replace with new configuration parts if damaged. NOTE Perform step 12.1 for vehicles with new configuration only. 12.1. Inspect gear teeth, splines, and machined surfaces of clutch ring gear (3), stage one sun gear (4), stage one gear carrier (5), stage two gear carrier (6), stage three gear carrier (9), and ring gear (8) for damage. Replace any damaged parts. TM 9-2320-280-34 15-8 Change 1 NEW CONFIGURATION OLD CONFIGURATION