TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 736 of 1258
TM 9-2320-280-34 14 - 28. AMBULANCE WINDSHIELD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Manual References M996, M996A1, M997, M997A1, M997A2 TM 9-2320-280-20 TM 9-2320-280-24P Tools General mechanic's tool kit: Equipment Condition automotive (Appendix G, Item 1) Windshield wiper arm pivots removed (TM 9-2320-280-20). Materials/Parts Wood block, 4 in. x 4 in., 40 in. (1016 mm) long General Safety Instructions Wood block, 4 in. x 4 in., 24 in. (610 mm) long Do not perform this procedure near fire, flames, or Twelve rivets (Appendix E, Item 140) sparks. Personnel Required Maintenance Level One mechanic Direct support One assistant a. Removal 1. Remove six capscrews (1) and washers (2) from two rear windshield mounting brackets (5) and windshield (4). Remove shims (3) from behind mounting brackets (5), if present. 2. Remove three screws (7), clamps (6), antenna cables (8), and intercom cable (9) from windshield (4). 3. Remove three hitch pins (10) and windshield hinge pins (12) from front hinges (11) and lower hinges (13). NOTE · Perform steps 4, 5, and 7 for M996 and M996A1 vehicles only. · Have drainage container ready to catch fuel. 4. Close heater fuel shutoff valve (14) at heater fuel line (15). WARNING Diesel fuel is highly flammable. Do not perform this procedure near fire, flames, or sparks. Severe injury or death will result. 5. Disconnect heater fuel line (15) above shutoff valve (14). 6. Remove two capscrews (17) and washers (16) from front of ambulance body (18) and cargo floor (19). 14-136