TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 733 of 1258
TM 9-2320-280-34 14 - 27 . AIR CONDITIONING COMPRESSOR REPAIR (Cont’d) 14. Install field coil (13) onto seal housing (4), making sure bump on field coil (13) fits in locating depression on compressor housing (14). Using snapring pliers, install snapring (12) on seal housing (4) to secure field coil (13). 15. Install field coil lead wires (15) on compressor housing (14) with clip (9) and screw (8). CAUTION Do not clamp compressor body in vise. Clamp or support only at mounting ears, with blocks of wood, to prevent damage to compressor body. 16. Clamp compressor housing (14) in vise with blocks of wood on mounting ears. 17. Place rotor pulley (10) on seal housing (4), making sure it is not misaligned or crooked. 18. Place rotor pulley installer into bearing cavity of rotor pulley (10), making sure the outer edge of the installer rests on the bearing outer race (11). CAUTION Make sure all slack is taken out of field coil lead wires (with clamp) before installing rotor pulley to prevent damage to lead wires. 19. Place driver on rotor pulley installer, and tap driver with hammer until rotor pulley (10) fully seats on seal housing (4). 14-133