TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 630 of 1258
TM 9-2320-280-34 14-7 BLAST SHIELD REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Manual References M966, M996A1, M1036, M1045, M1045A1, TM 9-2320-280-24P M1045A2, M1046, M1046A1 Materials/Parts Maintenance Level Twenty-eight rivets (Appendix E, Item 141) Direct Support Adhesive sealant (Appendix B, Item 3) NOTE If blast shield is secured with spot welds, replace with kit 57K0223. Installation instructions are included with kit. If it is riveted, proceed with task. For instructions on replacement of rivets, refer to para. 22-7. a. Removal Remove twenty-eight rivets (1) and blast shield (2) from roof (3). Discard rivets (1). b. Installation NOTE Use old blast shield as a template for drilling holes in new blast shield before installing on vehicle. 1. Using old blast shield as a template, locate, mark, and drill twenty-eight .194-in. (4.93 mm) diameter holes in new blast shield. 2. Apply adhesive sealant to blast shield (2) and install blast shield (2) on roof (3) with twenty-eight rivets (1). 14-30