TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 622 of 1258
TM 9-2320-280-34 14-6. CARGO SHELL REPLACEMENT This task covers: a. Removal b. Installation INITIAL SETUP: Applicable Models Manual References All except M996, M996A1, M997, M997A1, TM 9-2320-280-20 M997A2, M998, M998A1, M1035, M1035A1, TM 9-2320-280-24P M1035A2, M1037, M1038, M1038A1, M1042, M1097, M1097A1, M1097A2 Equipment Condition Cargo shell door removed (TM 9-2320-280-20). Tools Front and rear strikers removed General mechanic's tool kit: (TM 9-2320-280-20). automotive (Appendix G, Item 1) Antenna removed (TM 9-2320-280-20), if present. Materials/Parts Dovetail spring removed (TM 9-2320-280-20). M966, M966A1, M1036, M1045, M1045A1, Nineteen locknuts (Appendix E, Items 57) M1045A2, M1046, and M1046A1 only: Two locknuts (Appendix E, Item 60) M16 ammo rack removed, left cargo shell only Seven rivets (Appendix E, Item 140) (TM 9-2320-280-20). Nut and lockwvasher assembly M1043, M1043A1, M1043A2, M1044, and M1044A1 (Appendix E, Item 96) only: Grease (Appendix B, Item 21) Ammo box tray removed (TM 9-2320-280-20). Adhesive tape (Appendix B, Item 58) Maintenance Level Personnel Required Direct support One mechanic One assistant NOTE • The procedures for removing and installing the right cargo shell and left cargo shell are basically the same. This procedure covers the right cargo shell. • For instructions on replacement of rivets, refer to para. 22-7. a. Removal 1. Remove seven rivets (19) and panel (18) from cargo shell (8) and wheelhouse (11). 2. Remove two locknuts (9), washers (10), and screws (13) from cargo shell (8) and striker mounting plate (12). Discard locknuts (9). 3. Remove nine locknuts (14), washers (7), capscrews (6), washers (7), and spacers (17) from cargo shell (8) and wheelhouse (11). Discard locknuts (14). 4. Remove two locknuts (15), washers (16), capscrews (20), and washers (16) from cargo shell support tube (2) and wheelhouse (11). Discard locknuts (15). 5. Remove two locknuts (5), washers (4), capscrews (3), and washers (4) from cargo shell support tube (2) and 'C, pillar (1). Discard locknuts (5). 6. Remove capscrew (28), washer (27), snubber (26), mount (25), bushing (24), and plate (22) from rear ring support (23) and C" pillar support bracket (21). 14-22