TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download

Page 591 of 1258

TM 9-2320-280-34 12-19. REAR SUSPENSION FRONT CROSSMEMBER REPLACEMENT (Cont’d) b. Installation 1. Install two crossmember mounting brackets (7) on front crossmember (4) with two washers (2), capscrews (3), washers (2), and locknuts (1). 2. Install four washers (6), capscrews (5), washers (6), and locknuts (12) on crossmember mounting brackets (7) and front crossmember (4). 3. Install front crossmember (4) on frame rails (13). 4. Install rear-front tiedown brackets (para. 12-15). 5. Tighten four locknuts (12) to 260 lb-ft (353 N.m) and two locknuts (1) to 90 ft-lb (122 N.m). 6. Install two radius rods (10) on crossmember mounting brackets (7) with washers (9), capscrews (11), washers (9), and locknuts (8). Tighten locknuts (8) to 260 lb-ft (353 N.m). 7. Install brake line (18) and connect to tee (16) and tube coupling (22). 8. Install brake line (18) and vent line (17) on front crossmember (4) with three clamps (15) and capscrews (14). 9. Install parking brake caliper and mounting bracket (19) on front crossmember (4) with two washers (21), capscrews (23), washers (21), and locknuts (20). Tighten locknuts (20) to 90 lb-ft (122 N.m). 12-34