TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 458 of 1258
TM 9-2320-280-34 6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd) 69. Install harness (6) on body (33) with four clamps (26), capscrews (25), and locknuts (27). 70. Connect harness leads 67C (29) and 67E (30) on parking brake switch (21). 71. Connect harness leads 14A (1), 14B (2), and 40F (34) on shift controls housing(35). NOTE Perform step 72 for M1035, M1035A1 and M1035A2 only. 72. Connect harness leads 467C (31) and 457D (32) to shift controls housing (35). 73. Install harness (6) on body (33) with clamp (24) and two screws (23). 74. Install harness (6) and harness (10) on body (33) with clamps (7) and (9) and screws (8) and (11). NOTE Perform step 75 for 6.5 L only. 75. Connect harness leads (14) and (15) to transmission and transfer case indicator lights (12) and (13). 76. Install harness (6) on body (33) with clamp (19), capscrew (18), and locknut (20). 77. Install harness (6) on parking brake boot (22) with clamp (16), capscrew (17), and locknut (28). 78. Install harness (6) on body (33) with clamp (5), capscrew (4), and locknut (3). 79. Connect harness lead 36A (36) to engine oil pressure sending unit (37). 80. Connect harness leads 33A (40) and 58B (41) to engine harness leads 33A (39) and 58B (38). 81. Install harness (6) on cowl (44) with three clamps (46), capscrews (47), and locknuts (45). 82. Install harness (6) on cowl (44) with clamp (48) and locknut (49). 83. Apply lubricating oil to harness connector (42) and to brake warning lamp switch (43). 84. Connect harness connector (42) to brake warning lamp switch (43). 85. Connect harness leads 25A (57) and 26A (58) to horn (50). 86. Install harness (6) on crossmember (54) with clamp (56) and screw (55). 87. Install harness (6) on left airlift bracket (51) with three clamps (53) and screws (52). 6-110