TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 454 of 1258
TM 9-2320-280-34 6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd) 43. Install trailer connector (1) in bracket (2) with four capscrews (8) and nut and lockwasher assemblies (7). 44. Install harness (3) on body (6) with five clamps (5) and screws (4). 45. Apply antiseize compound to harness ground lead 95B (11) and install on buss bar (10) with lockwasher (12) and capscrew (13). 46. Apply antiseize compound to harness ground lead 95C (22) and install on left rear side marker light (19) with locknut (21) and screw (20). 47. Connect harness leads 21C (38), 22-461B (37), 23B (36), and 24B (35) to left rear composite light (9). NOTE Perform step 48 for M1035, M1035A1 and M1035A2 only. 48. Connect harness lead 467E (32) to backup light (39). Install ground lead 95D (18) to stud (31) with lockwasher (17) and nut (16). 49. Connect harness lead 489A (23) to left rear side marker light (19). 50. Install harness (3) on shield (15) with two clamps (27), capscrews (14), and nut and lockwasher assemblies (26). 51. Install shield (15) on body (6) with two lockwashers (25) and screws (24). 52. Install harness (3) on body (6) with clamp (28), capscrew (29), and nut and lockwasher assembly (30). 53. Install harness (3) on body (6) with two clamps (34) and screws (33). NOTE Perform steps 54 and 55 for 6.5 L only. 54. Install body harness (45) on dipstick support bracket (44) with screw (43), clamp (46), and nut (47). 55. Connect two leads 458A (40) to leads 458c (42) and 458d (41). 56. Install harness (3) on body (6) with three clamps (48) and screws (54). 57. Install harness (3) on body (6) with three clamps (52) and screws (53). 58. Connect harness leads 28A (51) and 58C (50) to fuel tank jumper harness (49). 6-106