TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 448 of 1258
CAUTION ______ Use care when installing harness. Snagging or pulling may damage harness. NOTE The top screws connecting the closeout plate may be longer than the rest, if the fuel filter drain tube is routed to the top of the closeout plate. NOTE Refer to TM 9-2320-280-20 for repair of wiring harness connectors. 1. Position harness (5) in approximate mounting position. Feed forward branch of harness (5) through hole (20). 2. Install left body mounts (para. 13-3). 3. Install grommet (19) over yellow locator tape (22) and position closeout plate (18) on grommet (19). 4. Install grommet (19) and closeout plate (18) on cowl (23) with four screws (24) and locknuts (21). 5. Install harness ground lead 57E (8) on heater motor (7) with washer (9) and screw (10). 6. Connect harness lead 400D (6) to heater motor (7). 7. Connect harness leads 27K (12), 57F (13), and 71C (11) to windshield wiper motor jumper harness (3). 8. Install harness (5) on “A” beam (2) with two clamps (14), capscrews (1), and locknuts (4). NOTE Perform step 9 for M1097, A1 and A2 series, and M1123. 9. Install screw (16) and transfer case indicator lamp ground lead (17) on cylinder head (15). 6-9. BODY WIRING HARNESS REPLACEMENT (Cont'd) b. Installation TM 9-2320-280-34 6-100 Change 1 M1097, A1 AND A2 SERIES, AND M1123