TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 427 of 1258
TM 9-2320-280-34 6-8. ENGINE WIRING HARNESS REPLACEMENT (Cont’d) NOTE Perform steps 27 through 29 for 200 amp regulator only. 27. Install washer (9), lead (6), and nut (8) on terminal (10). Tighten nut (8) to 1822 lb-in. (2.0-2.5 N • m). Slide rubber boot (7) over terminal (10). 28. Install washer (12), lead 5A (13), and nut (14) on red (energize) terminal (11). Tighten nut (14) to 23-27 lb-in. (2.6-3.0 N.m). Slide rubber boot (15) over terminal (11). 29. Install washer (4), lead 2A (3), and nut (2) on yellow (AC) terminal (5). Tighten nut (2) to 18-22 lb-in. (2.0-2.5 N.m). Slide rubber boot (1) over terminal (5). 6-80