TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 402 of 1258
TM 9-2320-280-34 6-6. STARTER REPAIR (Cont’d) 8. Apply aircraft grease to armature shaft (32), shift lever studs (26), and the inside diameter of end plate seal (34). 9. Install washer (33), pinion housing end plate (36), gasket (37), and washer (30) on armature shaft (32). 10. Install clutch (29) on armature shaft (32) with pinion stop (28) and snapring (27). NOTE Armature and shift lever must be positioned as shown for installation into pinion housing. 11. Install shift lever (25) and armature (31) into pinion housing (38). Install pinion housing end plate (36) on pinion housing (38) with three screws (35). Tighten screws (35) to 40 lb-in. (5 N • m). 12. Install shift lever (25) on pinion housing (38) with pin (24) and two plugs (23). 6-55