TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 393 of 1258
TM 9-2320-280-34 6-6. STARTER REPAIR This task covers: a. Removal b. Assembly b. Cleaning e. Bench Testing and Adjusting c. Inspection INITIAL SETUP: Tools Materials/Parts (Cont'd) General mechanic's tool kit: Two locknuts (Appendix E, Item 50) automotive (Appendix G, Item 1) Pinion O-ring (Appendix E, Item 120) Washer kit (Appendix E, Item 213) Test Equipment Adhesive-sealant (Appendix B, Item 2) Switch (Appendix G, Item 91) Aircraft grease (Appendix B, Item 20) Multimeter (Appendix G, Item 120) Lithium grease (Appendix B, Item 22) Carbon pile (Appendix G, Item 92) Lubricating oil (Appendix B, Item 32) Armature test set (Appendix G, Item 93) Core shaft nut tool (Appendix C, Fig. 3) Materials/Parts Manual References Pinion stop and snapring kit TM 9-2320-280-20 (Appendix E, Item 125) TM 9-2320-280-24P Thrust washer and spacer kit (Appendix E, Item 209) Equipment Condition Gasket set (Appendix E, Item 41) Starter removed (TM 9-2320-280-20). Gasket set (Appendix E, Item 42) Core parts kit (Appendix E, Item 7) Maintenance Level Gasket kit, commutator end head Direct support (Appendix E, Item 40) a. Disassembly 1. Remove plug (4) and gasket (5) from pinion housing (3). Discard gasket (5). 2. Using core shaft nut tool, remove locknut (2) from end of core shaft (1) located inside pinion housing (3). Discard locknut (2). 6-46