TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 319 of 1258
6-3.1. 100 AMPERE ALTERNATOR (12340912) REPAIR (Cont’d) 24. Press bearing (9) on rotor shaft (17) and into drive end housing (7). 25. Install two brushes (6), O-rings (5), and brush holders (4) in drive end housing (7). Do not overtighten brush holder (4). 26. Connect two leads (1) to two brush holders (4) with two lockwashers (3) and terminal nuts (2). 27. Apply sealant to two terminal nuts (2) and brush holders (4). 28. Install O-ring (16) and drive housing spacer (15) on rotor shaft (17) with tapered end of spacer (15) facing toward O-ring (16). 29. Apply a small amount of grease on spacer (15). 30. Install seal (10) in drive end housing (7) with lip facing away from drive end housing (7). 31. Install bearing retainer (11) on drive end housing (7) with four screws (12). 32. Install woodruff key (8), washer (14), and nut (13) on rotor shaft (17). 33. Install woodruff key (21) on rotor shaft (17). 34. Install fan (20) on rotor shaft (17) over woodruff key (21) with washer (19) and screw (18). TM 9-2320-280-34 6-18.14 Change 1