TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 309 of 1258
6-3.1. 100 AMPERE ALTERNATOR (12340912) REPAIR (Cont’d) 11. Remove sealer from two brush holder terminal nuts (4). NOTE Prior to removal, tag leads for installation. 12. Remove two terminal nuts (4), lockwashers (5), and disconnect two leads (3) from two brush holder terminals (6). Discard lockwashers (5). 13. Remove sealer from two brush holders (7). Remove two brush holders (7), brushes (9), and O-rings (8) from drive end housing (1). Discard O-rings (8). 14. Using puller, push drive end of rotor shaft (10) out of drive end housing (1) and stator (2). 15. Remove sealer from three stator lead terminal screws (19). Remove three stator lead terminal screws (19) from three stator leads (20), electrical connector lead (16), and three rectifier mounts (18). 16. Scribe alignment marks (17) on drive end housing (1) and stator (2). Separate drive end housing (1) and stator (2). 17. Remove two screws (13), lockwashers (12), and terminal cover (11) from drive end housing (1). Discard lockwashers (12). 18. Remove two screws (14), lockwashers (15), and electrical connector (21) from drive end housing (1). Discard lockwashers (15). TM 9-2320-280-34 6-18.4 Change 1