TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 285 of 1258
TM 9-2320-280-34 4-10. ACCELERATOR CABLE MOUNTING BRACKET MAINTENANCE This task covers: a. Removal c. Installation b. Inspection INITIAL SETUP: Tools Equipment Condition General mechanic's tool kit: Hood raised and secured (TM 9-2320-280-10). automotive (Appendix G, Item 1) Maintenance Level Manual References Direct support TM 9-2320-280-10 TM 9-2320-280-20 TM 9-2815-237-34P a. Removal 1. Loosen two nuts (7) and disconnect cable assembly (1) from accelerator bracket (5). 2. Disconnect throttle return spring (2) from bracket (5). 3. Remove stop collar (6) and disconnect cable assembly (1) from fuel injection pump (4). 4. Remove nut (8) and washer (9) from fuel injection pump (4) and stud (11). 5. Remove two capscrews (10) and bracket (5) from fuel injection pump (4). b. Inspection Inspect throttle return spring (2) for damage. Replace if defective. c. Installation 1. Install bracket (5) on fuel injection pump (4) and stud (11) with washer (9) and nut (8). 2. Install bracket (5) on fuel injection pump (4) with two capscrews (10). Tighten capscrews (10) to 13 lb-ft (18 N m). 3. Position throttle shaft lever (3) to full throttle position and secure cable assembly (1) to throttle shaft lever (3) with stop collar (6). 4. Connect throttle return spring (2) to bracket (5). 5. Install cable assembly (1) to bracket (5) with two nuts (7). 4-20