TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 281 of 1258
TM 9-2320-280-34 4-8. FUEL INJECTION PUMP SHUTOFF SOLENOID MAINTENANCE This task covers: a. Removal c. Installation b. Inspection INITIAL SETUP: Tools Equipment Condition General mechanic's tool kit: Fuel injection pump cover removed (para. 4-7). automotive (Appendix G, Item 1) Manual References Materials/Parts TM 9-2320-280-20 Three lockwashers (Appendix E, Item 80) TM 9-2815-237-34P Locknut (Appendix E, Item 45) Two fiber washers (Appendix E, Item 14) Maintenance Level Direct support NOTE Working area should be clean, well ventilated, and free from blowing dirt and dust. a. Removal 1. Remove terminal (5), washer (6), and shell (7) from stud (12). 2. Remove nut (8), lockwasher (9), washer (10), and fiber washer (11) from stud (12). Discard lockwasher (9) and fiber washer (11). 3. Remove locknut (4), ground strap (3), lockwasher (2), nut (8), lockwasher (9), washer (10), and fiber washer (11) from stud (14). Discard locknut (4), lockwashers (2) and (9), and fiber washer (11). 4. Remove electrical shutoff solenoid (13) from cover (1). b. Inspection Inspect shell (7) for deterioration, cracks, or damage. Replace if cracked, deteriorated, or damaged. c. Installation 1. Install electrical shutoff solenoid (13) in cover (1). 2. Install fiber washer (11), washer (10), lockwasher (9), nut (8), lockwasher (2), ground strap (3), and locknut (4) on stud (14). 3. Install fiber washer (11), washer (10), lockwasher (9), and nut (8) on stud (12). 4. Install shell (7), washer (6), and terminal (5) on stud (12). 4-16