TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 261 of 1258
TM 9-2320-280-34 3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont’d) NOTE •Perform steps 31 through 34 for 6.2 L engines only. •Replace power steering drivebelts in matched sets only. 31. Feed belt set (14) into inner grooves on crankshaft pully (12), water pump pulley (13), and power steering pump pulley (11). 32. Install washer (18), lockwasher (17), and adjusting capscrew (16) through adjusting slot in alternator support bracket (19). Do not tighten capscrew (16). CAUTION Do not pry against power steering pump housing with pry bar when adjusting belt tension. Damage to equipment may result. NOTE •New belt tension should read 105 ± 5 lbs (476 ± 22 N). •Used belt tension should read 90 + 5 lbs (400 ± 22 N). 33. Using belt tension gauge, check each belt for proper tension. 34. Tighten two capscrews (15) and adjusting capscrew (16) to 40 lb-ft (54 N m) on power steering pump bracket (20), alternator bracket (19), and power steering pump (10). 35. Position wiring harness (25) in approximate mounting location. 36. Install wiring harness (25) on bracket (26) with capscrew (27), clamp (28), and nut (29). 37. Install wiring harness (25) on cylinder block (21) with clamp (22), lockwasher (23), and nut (24). 3-197