TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 259 of 1258
TM 9-2320-280-34 3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) (Cont’d) WARNING Alternator must be supported during installation. Failure to support alternator may cause injury to personnel or damage to equipment. NOTE •Perform steps 25 through 29 for vehicles equipped with 60 and 100 amp Prestolite alternator only. •In some cases, a thru-bolt and nut may be present on mounting bracket instead of standard capscrews and washers. 25. Install alternator (20) on mounting bracket (5) with support bracket (19) between mounting bracket and alternator (20) with two washers (18), lockwashers (17), and capscrews (16). 26. Align alternator (20), and adjusting bracket (12), and install washer (13), lockwasher (14), and capscrew (15). NOTE Perform steps 27 through 29 for vehicles with new alternator support bracket configuration. 27. Position alternator (21) on mounting bracket (28) with support bracket (27) on the outside of alternator (21) mounting flange. 28. Position spacer (26) between alternator (21) and mounting bracket (28). 29. Install alternator (21) and power steering lines bracket (25) on support bracket (21) and mounting bracket (28) with two washers (24), lockwashers (23), and capscrews (22). 3-195