TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 25 of 1258
TM 9-2320-280-34 CHAPTER 2 GENERAL MAINTENANCE Section I. REPAIR PARTS, SPECIAL TOOLS, TEST, MEASUREMENT AND DIAGNOSTIC EQUIPMENT (TMDE), AND SUPPORT EQUIPMENT 2-1. COMMON TOOLS AND EQUIPMENT Refer to Modified Table of Organization and Equipment (MTOE) for authorized common tools and equipment applicable to your unit. 2-2. SPECIAL TOOLS AND SUPPORT EQUIPMENT Special tools and support equipment are listed and illustrated in TM 9-2320-280-24P. 2-3. TEST, MEASUREMENT, AND DIAGNOSTIC EQUIPMENT (TMDE) Calibrate all measuring and test equipment used to determine equipment conformance in accordance with TB 43-1800. 2-4. FABRICATED TOOLS Fabricated tools needed to maintain the equipment in this manual can be found in appendix C. These tools are not available for issue, but must be fabricated and applied by direct and general support personnel only. 2-5. REPAIR PARTS Repair parts are listed and illustrated in TM 9-2320-280-24P, except for engine assembly repair parts which are listed and illustrated in TM 9-2815-237-34P. Pre-1990 and 1990 and above 6.2 L and 6.5 L engines have some new and revised parts which are not interchangeable. These part changes affect some of the maintenance procedures in chapters 3 and 4. Refer to engine decal on left rocker arm cover before performing maintenance procedures and ordering replacement parts. The 6.2 L engine is identified by a decal which is adhered to the left rocker arm cover. The 6.5 L engine is identified by a serial number bar code. 2-1