TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 249 of 1258
TM 9-2320-280-34 3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) NOTE Early production 6.2 L engines were equipped with a left engine heat shield. Removal is the same as right shield. 55. Loosen three socket head screws (1) and right heat shield (3) from exhaust manifold (2). Remove heat shield (3). 56. Loosen locknut (8) and washer (7) from front of starter (6) and bracket (9). WARNING Starter must be supported during removal. Failure to support starter may cause injury to personnel or damage to equipment. 57. Remove two capscrews (10), washers (11), starter (6), and shim(s) (5), if present, from engine (4). NOTE Perform step 58 for right engine mount on early production 6.2 L engines only. 58. Remove two capscrews (17), lockwashers (16), and starter support bracket (12) from right engine mount and insulator assembly (13). Discard lockwashers (16). 59. Remove three capscrews (15), lockwashers (14), and left and right engine mount and insulator assembly (13) from engine (4). Discard lockwashers (14). 60. Remove two nuts (19), lockwashers (18), and wiring harness bracket (20) from oil pan. Discard lockwashers (18). 3-186