TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 238 of 1258
TM 9-2320-280-34 3-26. ENGINE PREPARATION (6.2 L AND 6.5 L) NOTE • Perform steps 7 through 13 for vehicles equipped with a 60 amp alternator. • Prior to removal, tag all leads for installation. 7. Remove two screws (6), lockwashers (7), and wire retaining strap (8) fromalternator (22) and remove wire retaining strap (8), spacer (9), and washer (10). Discard lockwashers (7). 8. Remove two screws (1) and lockwashers (27) from terminal cover (2). Discard lockwashers (27). 9. Pry cover (2) away from waterproofing adhesive and remove cover (2). 10. Remove waterproofing adhesive from around terminals (23). 11. Disconnect lead 568A (12) from engine wiring harness (11). 12. Remove capscrew (3), lockwasher (4), and ground 3B (5) from alternator (22). Discard l ockwasher (4). 13. Remove two nuts (26), lockwashers (25), washers (24), and leads 5A (10) and 2A (9) from alternator (22). Discard lockwashers (25). NOTE There has been a change to the power steering lines support bracket. Perform step 14 for vehicles with original configuration. Perform step 15 for vehicles with new support bracket configuration. 14. Remove locknut (18), washer (19), capscrew (21), spacer (20), harness clamp (16), and clamp (17) from support bracket (15). Discard locknut (18). 15. Remove locknut (31), washer (32), capscrew (34), washer (33), harness clamp (28), and clamp (30) from support bracket (29). Discard locknut (31). 3-176