TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 220 of 1258
3-25. ENGINE INSTALLATION (6.5 L) (Cont’d) TM 9-2320-280-34 3-158 Change 1 NOTE • Perform steps 75 through 86 for vehicles equipped with Neihoff 100 amp alternator only. • Ensure terminals are clean before connections are made. 75. Install positive cable (10) on positive stud (9) with washer (12), lockwasher (13), and nut (14). Tighten nut (14) to 10-15 lb-ft (14-20 N•m) 76. Install ground cable (5) on alternator (6) with washer (3), lockwasher (2), and capscrew (1). Tighten capscrew (1) to 8-12 lb-ft (11-16 N•m). 77. Position drivebelt (7) on pulley (8). 78. Install rubber boots (11) and (4) over cables (5) and (10). 79. Apply sealing compound to threads of capscrew (18). 80. Install voltage regulator (19) on alternator (6) with lockwasher (17) and capscrew (18). Tighten capscrew (18) to 88-94 lb-in. (10-11 N•m) 81. Install two washers (22), lockwashers (21), and screws (20) on voltage regulator (19) and alternator (6). Tighten screws (20) to 30-34 lb-in. (3-4 N•m) 82. Install washer (24), lead (25), and nut (26) on terminal (23). Tighten nut (26) to 18-22 lb-in. (2.0-2.5 N•m). Slide rubber boot (27) over terminal (23). 83. Connect regulator connector (34) to alternator connector (33). 84. Install washer (38), lead 5A (37), and nut (36) on red (energize) terminal (39). Tighten nut (36) to 23-27 lb-in. (2.6-3.0 N•m). Slide rubber boot (35) over terminal (39). 85. Install washer (29), lead 2A (30), and nut (31) on yellow (AC) terminal (28). Tighten nut (31) to 18-22 lb-in (2.0-2.5 N•m). Slide rubber boot (32) over terminal (28). 86. Connect regulator plug (16) to voltage regulator (19).