TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 21 of 1258
TM 9-2320-280-34 1-8. MANDATORY REPLACEMENT PARTS The maintenance instructions contained herein make reference to removing and discarding piece parts such as: gaskets, lockwasher, cotter pins, O-ring seals, etc.; these items should be considered mandatory replacement items and replaced with new parts during assembly/installation. Section II. EQUIPMENT DESCRIPTION AND DATA 1-9. EQUIPMENT DESCRIPTION Detailed descriptions covering the 1-1/4 ton, 4X4, M998 series vehicles are in TM 9-2320-280-10 and TM 9-2320-280-20. 1-10. TABULATED DATA Tabulated data is listed in table 1-1. This information includes only that data applicable to direct support and general support maintenance. Information not covered can be found in TM 9-2815-237-34, TM 9-2320- 280-20, TM 9-2320-280-10. Table 1-1. Tabulated Data NOTE Standard and metric measurements will be used in this table and throughout the manual. A list of their abbreviations is provided below. TABULATED DATA ABBREVIATIONS MEASUREMENT ABBREVIATION MEASUREMENT ABBREVIATION Pint .................................................................. pt Celsius ............................................................. C Quart ................................ ............................... qt Liter ............................... ...................................1 Gallon .............................................................. gal. Centimeter ........................ ............................. cm Inch .............................. ................................... in. Kilometers Per Hour ...................................... kph Pound .............................................................. lb KiloPascal .................................................... kPa Miles Per Hour ................................................. mph Maximum ..................................................... max Pound Per Square Inch .................................... psi Minimum ....................................................... min Revolutions Per Minute .................................... rpm Kilogram ......................... ................................ kg Pound-Feet ...................................................... lb-ft Newton Meter ............................................... N.m Gallons Per Minute ................... ....................... gpm Millimeter ..................................................... mm Volt .................................................................. V Ampere ............................................................ A Horsepower .......................... ........................... hp Liters Per Minute ...........................................Ipm Fahrenheit ............................ ........................... F KiloWatt ........................................................ kW 1-3