TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 188 of 1258
NOTE • Perform steps 53 through 63 for vehicles equipped with Neihoff 100 amp alternator only. • Prior to removal, tag leads for installation. 53. Disconnect regulator plug (1) from voltage regulator (4). 54. Slide back rubber boot (21) and remove nut (22), lead 5A (23), and washer (24) from red (energize) terminal (25). 55. Slide back rubber boot (18) and remove nut (17), lead 2A (16), and washer (15) from yellow (AC) terminal (14). 56. Slide back rubber boot (12) and remove nut (11), lead (10), and washer (9) from terminal (8). 57. Disconnect regulator connector (20) from alternator connector (19). 58. Remove two screws (5), lockwasher (6), washer (7), securing voltage regulator (4) to alternator (13). Discard lockwasher (6). 59. Remove capscrew (3), lockwasher (2), and voltage regulator (4) from alternator (13). Discard lockwasher (2). 60. Slide back rubber boot (29) and remove capscrew (26), lockwasher (27), washer (28), and ground cable (30) from alternator (13). Discard lockwasher (27). 61. Slide back rubber boot (35) and remove nut (38), lockwasher (37), washer (36), and alternator positive cable (34) from positive stud (33). Discard lockwasher (37). 62. Deleted. 63. Remove drivebelt (31) from alternator pulley (32). 3-24. ENGINE REMOVAL (6.5 L) (Cont’d) TM 9-2320-280-34 3-126 Change 1