TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 160 of 1258
TM 9-2320-280-34 3 - 23. ENGINE INSTALLATION (6.2L) (Cont’d) NOTE Installation for the 100 amp and 200 amp Neihoff regulators are basically the same. Differences are shown in the illustration. 91. Apply sealing compound to threads of capscrew (10). 92. Install spacer (14) and voltage regulator (12) on alternator (15) with lockwasher (11) and capscrew (10). Tighten capscrew (10) to 88-94 lb-in. (10-11 N m). 93. Install two washers (16), lockwashers (17) and screws (18) on voltage regulator (12) and alternator (15). Tighten screws (18) to 30-34 lb-in (3-4 N m). 94. Install washer (1), lead 5A (2), and nut (3) on red (energize) terminal (19). Tighten nut (3) to 23-27 lb-in. (2.6-3.0 N m). Slide rubber boot (4) over terminal (19). 95. Install washer (8), lead 2A (7), and nut (6) on yellow (AC) terminal (9). T ighten nut (6) to 18-22 lb-in. (2.0-2.5 N m). Slide rubber boot (5) over terminal (9). 96. Connect regulator plug (13) to voltage regulator (12). 3-98