TM-9-2320-280-34 HMMWV Direct Support & General Support Maintenance Manual Download
Page 148 of 1258
TM 9-2320-280-34 3-23. ENGINE INSTALLATION (6.2 L) (Cont'd) 12. Install leads 74A (3) and 74B (5) on solenoid (2) with clip (6) and screw (7). NOTE Steps 13 through 16 apply to vehicle M1026, M1036, M1038, M1042, M1044, and M1046 only. Proceed to step 17 for all other vehicle models. 13. Install positive cable 6A (17), lead 81A (4), lead 81B (8), and lead 6 (22) on starter terminal (23) with lockwasher (10) and nut (9). Using torque adapter, tighten nut (9) to 25 lb-ft (34 N m). 14. Install negative cable 7A (16), lead 3D (13), and lead 7 (25) on starter terminal (24) with lockwasher (12) and nut (11). Using torque adapter, tighten nut (11) to 15 lb-ft (20 N m). 15. Install two clamps (14), positive cable 6A (17), and negative cable 7A (16) on starter (1) with screw (15). 16. Install clamp (21) and leads 6 (22) and 7 (25) on oil pan bracket (19) with capscrew (20) and nut and lockwasher assembly (18). 17. Connect positive cable 6A (17), lead 81A (4), and lead 81B (8) to starter (1) with lockwasher (10) and nut (9). 18. Connect negative cable 7A (16) and lead 3D (13) to starter (1) with lockwasher (12) and nut (11). 19. Install two clamps (14), positive cable 6A (17), and negative cable 7A (16) on starter (1) with screw (15). 20. Using torque adapter, tighten nut (11) to 15-lb-ft (20 N m) and nut (9) to 25 lb-ft (34 N m). 3-86